|
All Guns Are Inherently
Dangerous And Should Only Be Handled By Qualified Individuals Trained In Proper Safety
Procedures!
Clean The Magazine First
Make The Gun Safe
Compress Magazine Spring
Lock Magazine Spring
Remove Magazine Spring
Clean Inside Magazine
Clean The Spring
Wipe Inside Magazine
Remove Rag
Reinstall Spring
Recompress Spring
Insert Follower
Apply Oil
Clean The Gun Itself
Make The Gun Safe
Engage The Slide Lock
Remove Barrel Bushing
Remove Slide Lock
Remove Slide
Remove Firing-Pin
Remove Extractor
Clean Extractor
Clean Breech Face
Clean Feed Ramp
Clean And Reassemble
Position Barrel Link
Install Slide Lock
Complete Reassembly
Check Proper Functioning |
Insert a
small nail or other device into one of the holes in the side of the magazine after
compressing the spring to lock the spring low in the magazine in a compressed state. Be
sure not to insert the nail inside the loop on the bore brush. Gently remove the bore
brush after the spring is locked. Be careful as the spring is under tension. Point in a
safe direction in case the spring takes off. Shake the magazine and the magazine follower
should fall out. |
. |
|
